586
6-3. Do-it-yourself maintenance
2 Select on the multimedia dis-
play.
3 Select “Vehicle customize”.
4 Select “Tire pressure”.
5 Select the wheel set (“Set 1” or “Set
2”) displayed for the set selection
setting.
6 Select the wheel set you wish to
register, and then select “OK”.
The tire pressure warning light will slowly
blink 3 times, a message indicating that
change is occurring will be displayed, and
the wheel set change will begin.
Wheel set change will begin and the tire
pressure warning light will blink for
approximately 1 minute and then illumi-
nate. Also, while the change is being per-
formed, “---” will be displayed for the tire
inflation pressure of each tire on the multi-
information display.
After approximately 2 minutes, the wheel
set change will complete, the tire pressure
warning light will turn off, and a completion
message will be displayed on the multi-
information display.
If changing does not complete after
approximately 4 minutes, a message indi-
cating that the change could not be com-
pleted will be displayed.
Check which wheel set is installed and per-
form the change procedure again from the
beginning.
7 If the specified tire inflation pres-
sure of the wheel set installed dif-
fers from that of the previous set, it
will be necessary to perform the
tire inflation pressure setting pro-
cedure of the tire pressure warning
system. (P.581)
If the specified tire inflation pressure is the
same, it will not be necessary to perform
the tire inflation pressure setting proce-
dure.
8 Register the position of each wheel.
(P.580)
To Next Page
Loading...
