600
6-3. Do-it-yourself maintenance
■ After a fuse is replaced
● When installing the lid, make sure that the
tab is installed securely.
● If the lights do not turn on even after the
fuse has been replaced, a bulb may need
replacement. (P.601)
● If the replaced fuse blows again, have the
vehicle inspected by your Lexus dealer.
■ If there is an overload in a circuit
The fuses are designed to blow, protecting
the wiring harness from damage.
■ When replacing an electronic compo-
nent, such as a lights, etc.
Lexus recommends that you use genuine
Lexus products designed for this vehicle.
Because certain electronic components
are connected to circuits designed to pre-
vent overload, non-genuine parts or parts
not designed for this vehicle may be unus-
able.
Adjustment bolt A
Adjustment bolt B
Make sure the vehicle has a full tank
of gasoline and the area around the
headlight is not deformed.
Park the vehicle on level ground.
Make sure the tire inflation pressure
is at the specified level.
Have someone sit in the driver’s
seat.
Bounce the vehicle several times.
1 Using a Phillips-head screwdriver,
turn bolt A in either direction.
■ To prevent system breakdowns and
vehicle fire
Observe the following precautions.
Failure to do so may cause damage to
the vehicle, and possibly a fire or injury.
● Never use a fuse of a higher amperage
rating than that indicated, or use any
other object in place of a fuse.
● Always use a genuine Lexus fuse or
equivalent.
Never replace a fuse with a wire, even
as a temporary fix.
● Do not modify the fuses or fuse boxes.
■ Before replacing fuses
Have the cause of electrical overload
determined and repaired by your Lexus
dealer as soon as possible.
Headlight aim
Vertical movement adjusting
bolts
Before checking the headlight
aim
Adjusting the headlight aim
A
B
To Next Page
Loading...
