637
7-2. Steps to take in an emergency
7
When trouble arises
these steps.
1 Loosen the bolt using a wheel nut
wrench.
2 Assemble the jack handle bar, jack
handle extension bar and wheel nut
wrench and tighten the bolts.
Check that the bolts are firmly tightened.
4 Position the jack at the jack points
as shown.
Front
Rear
5 Raise the vehicle until the tire is
slightly raised off the ground.
6 Remove all the wheel nuts and the
tire.
When resting the tire on the ground, place
the tire so that the wheel design faces up to
avoid scratching the wheel surface.
To Next Page
Loading...
