646
7-2. Steps to take in an emergency
In the event that the hybrid system still
cannot be started, contact your Lexus
dealer.
■ Stopping the hybrid system
Shift the shift position to P, set the parking
brake and press the power switch as you
normally do when stopping the hybrid sys-
tem.
■ Replacing the key battery
As the above procedure is a temporary
measure, it is recommended that the elec-
tronic key battery be replaced immediately
when the battery is depleted. (P.595)
■ Alarm
If a door is unlocked using the mechanical
key when the alarm system is set, the alarm
may be triggered. (P.73)
■ Changing power switch modes
Release the brake pedal and press the
power switch in step 3 above.
The hybrid system does not start and modes
will be changed each time the switch is
pressed. (P.207)
If you have a set of jumper (or booster)
cables and a second vehicle with a 12-
volt battery, you can jump start your
vehicle by following the steps below.
1 Confirm that the electronic key is
being carried.
When connecting the jumper (or booster)
cables, depending on the situation, the
alarm may activate and the doors locked.
(P.74)
2 Open the hood (P.566), and
remove the engine compartment
cover. (P.568)
3 Open the right-hand side fuse box
cover.
If the 12-volt battery is dis-
charged
The following procedures may be
used to start the hybrid system if the
vehicle’s 12-volt battery is dis-
charged.
You can also call your Lexus dealer
or a qualified repair shop.
Restarting the hybrid system
To Next Page
Loading...
