Lexus NX 200 - Page 198

197
4
LEXUSNX300/NX200OwnersManualGeneralM78540en
4-3. Operating the lights and wipers
Driving
When any of the following are performed,
the battery-saving function is canceled
once and then reactivated. All the lights will
turn off automatically 20 minutes after the
battery-saving function has been reacti-
vated:
● When the headlight switch is operated
● When a door is opened or closed
■ Customization
Settings (e.g. light sensor sensitivity) can be
changed.
(Customizable features: P.482)
 Left-hand drive vehicles
1 With the headlights on, push the
lever away from you to turn on the
high beams.
Pull the lever toward you to the center
position to turn the high beams off.
2 Pull the lever toward you and
release it to flash the high beams
once.
You can flash the high beams with the
headlights on or off.
 Right-hand drive vehicles
1 With the headlights on, push the
lever away from you to turn on the
high beams.
Pull the lever toward you to the center
position to turn the high beams off.
2 Pull the lever toward you and
release it to flash the high beams
once.
You can flash the high beams with the
headlights on or off.
This system allows the headlights to be
turned on for 30 seconds when the
engine switch is off.
Pull the lever toward you and release it
with the light switch is in or
NOTICE
■ To prevent battery discharge
Do not leave the lights on longer than
necessary when the engine is off.
Turning on the high beam head-
lights
Follow me home system (if
equipped)