Lexus NX 200 - Page 277

276
LEXUSNX300/NX200OwnersManualGeneralM78540en
4-5. Using the driving support systems
■ Stop & Start system operation when the
brake hold system is operating
● If the engine is restarted automatically by
the Stop & Start system when the brake
hold system is operating, the brake hold
system will continue to apply the brakes.
● If the operation conditions of the brake
hold system are no longer met while the
engine is stopped by the Stop & Start sys-
tem, the brake hold system will stop oper-
ating. At this time, the parking brake will
be applied automatically and the engine
will be restarted automatically.
Press the Stop & Start cancel switch to
disable the Stop & Start system.
The Stop & Start cancel indicator will
come on.
Pressing the switch again to re-enable the
Stop & Start system.
■ If the Stop & Start cancel switch is
pressed while the vehicle is
stopped
 When the engine is stopped by the
Stop & Start system, pressing the
Stop & Start cancel switch will
restart the engine. From the next
time the vehicle is stopped (after
Stop & Start system has been turned
off), the engine will not be stopped.
 With the Stop & Start system dis-
abled, pressing the Stop & Start
cancel switch will re-enable the sys-
tem but not stop the engine. From
the next time the vehicle is stopped
(after Stop & Start system has been
turned on), the engine will be
stopped.
Disabling the Stop & Start sys-
tem