9. Once the updated data has finished copying, remove the USB flash drive.
INFORMATION
The vehicle information written to the USB flash drive is also required when updating the
sof
tware on this system, so do not delete the vehicle information on the USB flash drive
until the update has completed.
■ Updating the softw
are
1. Touch [
] from the main menu.
2. Touch [Software update] on the submenu.
3. Insert the USB flash drive with the copied update data into the USB port on
the vehicle.
4. Touch [Update software].
● The update data is copied and installation begins. (This will take about 10 to
15 minutes)
● Once installation is complete, a message is displayed stating that the update
has finished.
● System needs to be restarted, a message will appear. Touching [Yes] restarts
the system.
5. Remove the USB flash drive.
● To check the software update history, touch [History] on the software
update history screen.
● If the software update was done offline, an update completion report data
will be created on the USB flash drive. It is necessary to upload the update
completion report data to the portal site.
NOTICE
Do not remove the USB flash drive while the software is updating.
Related Links
Connecting the USB port(P. 34)
2-8. Vehicle settings
71
2
Settings and registration
To Next Page
Loading...
