119
2. DESTINATION SEARCH
NX300h/NX200t_Navi_OM78105U_(U)
15.06.25 12:26
NAVIGATION SYSTEM
3
1 Select “Freeway Entrance / Exit”.
2 Enter a freeway name and select “OK”.
3 Select the desired freeway.
4 Select “Entrance” or “Exit”.
5 Enter a freeway entrance or exit name
and select “OK”.
6 Select the desired entrance or exit
name.
1 Display the “Destination” screen.
(P.107)
2 Select “Map”.
3 Scroll the map to the desired point and
select “Go to ”.
“A d j u s t L o c a t i o n ” : Select to adjust the posi-
tion in smaller increments. (P.92)
If a destination has already been set, “Go to
” and “Add to Route” will be displayed.
“Go to ”: Select to delete the existing des-
tination(s) and set a new one.
“Add to Route”: Select to add a destination.
The navigation system performs a search
for the route and the entire route map is
displayed. (P.12 1 )
SEARCHING BY FREEWAY
ENTRANCE/EXIT
● Be sure to use the complete name of the
freeway or highway, including the hyphen,
when entering the destination. Freeways
and interstates use an “I” (I-405). US
highways use the state designation before
the number (CA-118).
SEARCHING BY MAP
By selecting “Map” the last displayed lo-
cation is displayed again on the map
screen. You can search for a destination
from this map.
To Next Page
Loading...
