Lexus NX200t - If the Smart Access System with Push-Button Start Does Not Operate Properly; If the Smart Access System with Push-Button Start Has Been Deactivated in a Customized Setting; To Operate the System Properly; When the Vehicle Is Not Driven for Extended Periods

135
3-2. Opening, closing and locking the doors
3
Operation of each component
NX200t_U_OM78006U
● A sudden approach to the effective range or door handle may prevent the doors from
being unlocked. In this case, return the door handle to the original position and check
that the doors unlock before pulling the door handle again.
● If there is another electronic key in the detection area, it may take slightly longer to
unlock the doors after the door handle is gripped.
■ When the vehicle is not driven for extended periods
● To prevent theft of the vehicle, do not leave the electronic key within 6 ft. (2 m) of the
vehicle.
● The smart access system with push-button start can be deactivated in advance.
(P. 616)
■ To operate the system properly
Make sure to carry the electronic key when operating the system. Do not get the elec-
tronic key too close to the vehicle when operating the system from the outside of the
vehicle.
Depending on the position and holding condition of the electronic key, the key may not
be detected correctly and the system may not operate properly. (The alarm may go off
accidentally, or the door lock prevention may not operate.)
■ If the smart access system with push-button start does not operate properly
● Locking and unlocking the doors: Use the mechanical key. (P. 577)
● Starting the engine: P. 579
■ Customization
Settings (e.g. smart access system with push-button start) can be changed.
(Customizable features: P. 614)
■ If the smart access system with push-button start has been deactivated in a customized
setting
● Locking and unlocking the doors:
Use the wireless remote control or mechanical key. (P. 114, 577)
● Starting the engine and changing engine switch modes: P. 579
● Stopping the engine: P. 193