377
5-7. Connecting Bluetooth
®
5
Lexus Display Audio system
NX200t_U_OM78006U
Connecting a Bluetooth
®
phone
When you register a phone, auto connection will be activated. It is recom-
mended to have the system set to this mode and leave the Bluetooth
®
phone in a
place where a good connection can be established.
When the engine switch is turned to ACCESSORY or IGNITION ON mode,
the system will search for a nearby cellular phone you have registered.
Next, the system automatically connects with the most recent phone that was
connected. The connected result is displayed.
When auto connection has failed or “Bluetooth
* Power” is turned off, you must
connect the Bluetooth
®
device manually.
Go to “Bluetooth
* Setup”: “MENU” button “Setup” “Bluetooth*”
Select the device to connect.
Select “Connect All”, “Connect as a Phone” or “Connect as an Audio player”.
If the desired Bluetooth
®
device is not displayed, register the device.
(P. 374)
*: Bluetooth is a registered trademark of Bluetooth SIG, Inc.
■ Reconnecting a Bluetooth
®
phone
If the system cannot connect due to poor signal strength with the engine switch in
ACCESSORY or IGNITION ON mode, the system will automatically attempt to recon-
nect.
If the phone is turned off, the system will not attempt to reconnect. In this case, the con-
nection must be made manually, or the phone must be reselected.
■ Connecting a phone while Bluetooth
®
audio is playing
● Bluetooth
®
audio will stop temporarily.
● It may take time to connect.
There are two connecting methods available: automatic and manual.
Auto connection
Manual connection
To Next Page
Loading...
