• The distance between the vehicle and a vehicle ahead
• When a vehicle ahead only has lights illuminated on one side
• When a vehicle ahead is a two-wheeled vehicle
• The condition of the road (gradient, curve, condition of the road surface, etc.)
• The number of passengers and amount of luggage
● The headlights may change between the high beams and low beams unexpectedly.
● Bicycles and other small vehicles may not be detected.
● In the following situations, the system may not be able to correctly detect the bright-
ness of the surroundings. This may cause the low beams to remain on or the high
beams to flash or dazzle pedestrians or vehicles ahead. In such a case, it is necessary
to manually change between the high beams and low beams.
•
When there are lights similar to headlights or tail lights in the surrounding area
•
When headlights or tail lights of vehicles ahead are turned off, dirty, changing color,
or not aimed properly
•
When the headlights are repeatedly changing between the high beams and low
beams.
•
When use of the high beams is inappropriate or when the high beams may be
flashing or dazzling pedestrians or other drivers.
• When the vehicle is used in an area in which vehicles travel on the opposite side
of the road of the country for which the vehicle was designed, for example using a
vehicle designed for right-hand traffic in a left-hand traffic area, or vice versa
• When it is necessary to disable the system: → P.349
• Situations in which the sensors may not operate properly: → P.354
■ Temporarily reducing front camera sensitivity
The sensitivity of the front camera can be temporarily reduced.
1. Turn the engine switch off with the following conditions met.
● The headlight switch is in the [
] or [AUTO] position.
● The headlight switch lever is in the low beam position.
● The automatic High Beam switch is on.
2. Turn the engine switch to ON.
3. Within 60 seconds after performing step 2, push the headlight switch lever to the
high beam position then pull it to the original position quickly 10 times, then leave the
lever in its original position.
4. If the sensitivity is changed, the Automatic High Beam indicator will blink 3 times.
3-1. Driving when the surrounding area is dark
207
3
Driving according to the conditions
To Next Page
Loading...
