After approximately 2 minutes, the wheel set
change will complete, the tire pressure warning
light will turn off, and a completion message will
be displayed on the multi-information display.
If changing does not complete after approximate-
ly 4 minutes, a message indicating that the change
could not be completed will be displayed.
Check which wheel set is installed and perform
the change procedure again from the beginning.
7 If the specified tire inflation pressure of the wheel set installed differs from that
of the previous set, it will be necessary to perform the tire inflation pressure
setting procedure of the tire pressure warning system.
If the specified tire inflation pressure is the same, it will not be necessary to perform the
tire inflation pressure setting procedure.
8 Register the position of each wheel.
Related Links
Registration of the position of each wheel after performing a tire rotation(P. 535)
8-5. Tire maintenance
543
8
Maintenance and care
To Next Page
Loading...
