Installing child restraint system using a seat belt (child restraint lock function
belt)
A child restraint system for a small child or baby must itself be properly restrained
on the seat with the lap portion of the lap/shoulder belt.
Install the child restraint system in accordance to the operation manual enclosed
with the child restraint system.
Rear-facing - Infant seat/convertible
1 Adjust the rear seat
If there is a gap between the child seat and the seatback, adjust the seatback until good
contact is achieved.
2 Place the child restraint system on the rear
seat facing the rear of the vehicle.
3 Run the seat belt through the child restraint
system and insert the plate into the buckle.
Make sure that the belt is not twisted.
4 Fully extend the shoulder belt and allow it to
retract to put it in lock mode. In lock mode,
the belt cannot be extended.
1-3. Preparations for safe driving with children in the vehicle
44
To Next Page
Loading...
