5 Fully extend the shoulder belt and allow it to
retract to put it in lock mode. In lock mode,
the belt cannot be extended.
6 While pushing the child restraint system into
the rear seat, allow the shoulder belt to re-
tract until the child restraint system is securely
in place.
After the shoulder belt has retracted to a point
where there is no slack in the belt, pull the belt to
check that it cannot be extended.
7 If the child restraint has a top tether strap, follow the child restraint manufactur-
er’s operation manual regarding the installation, using the top tether strap to
latch onto the top tether strap anchor.
8 After installing the child restraint system, rock it back and forth to ensure that it
is installed securely.
Booster seat
1 If installing the child restraint system to the front passenger seat is unavoidable,
refer to → P.56.
2 High back type: If the head restraint interferes with your child restraint system,
and the head restraint can be removed, remove the head restraint. Otherwise,
put the head restraint in the upper most position.
3 Place the child restraint system on the seat facing the front of the vehicle.
Booster type
1-3. Preparations for safe driving with children in the vehicle
46
To Next Page
Loading...
