● Pull a manual release handle
■ Conditions under which the system may not function correctly
● The Safe exit assist may not detect vehicles correctly in the following situations:
• When the sensor is misaligned due to a strong impact to the sensor or its surround-
ing area
• When mud, snow, ice, a sticker, etc., is covering the sensor or surrounding area on
the rear bumper
• When driving on a road surface that is wet with standing water during bad weather,
such as heavy rain, snow, or fog
•
When a vehicle or bicycle approaches from behind a nearby parked vehicle
•
When an approaching vehicle or bicycle suddenly changes direction
•
Immediately after a vehicle or bicycle starts moving
•
When the back door is open
•
When a bicycle carrier, ramp, or other accessory is installed to the back of the
vehicle
•
When a parked vehicle, wall, sign, person or other stationary object is behind the
vehicle
• When the vehicle is stopped at an angle to the road
• When a vehicle is traveling near an approaching vehicle or bicycle
• When an approaching vehicle or bicycle is traveling along a stationary object, such
a wall or sign
• When a vehicle or bicycle is approaching at high speed
• When towing with the vehicle
• When stopped on a steep slope
• When stopped on a curve or at the exit of a curve
● Instances of the Safe exit assist unnecessarily detecting a vehicle and/or object may
increase in the following situations:
• When the sensor is misaligned due to a strong impact to the sensor or its surround-
ing area
• When a vehicle or bicycle approaches from behind your vehicle at an angle
• When the vehicle is stopped at an angle to the road
• When a vehicle or bicycle approaches from behind a parked vehicle at an angle
• When a parked vehicle, wall, sign, person or other stationary object is behind the
vehicle
•
When an approaching vehicle or bicycle suddenly changes direction
6-2. Using the safe driving support functions
397
6
Driving support system