19
RX500h/RX350h_QG_U
When Driving
1
Pull the parking brake switch to check that the parking brake is set.
The parking brake indicator will come on.
2
Firmly depress the brake pedal.
and a message will be displayed on the multi-information display.
If it is not displayed, the hybrid system cannot be started.
When the shift position is N, the hybrid system cannot start.
Shift the shift position to P when starting the hybrid system.
3
Press the power switch shortly and
firmly.
When operating the power switch, one
short, firm press is enough. It is not nec-
essary to press and hold the switch.
If the “READY” indicator turns on, the
hybrid system will operate normally.
Continue depressing the brake pedal
until the “READY” indicator is illumi-
nated.
The hybrid system can be started from
any power switch mode.
4
Check that the “READY” indicator is
illuminated.
The vehicle will not move when the
“READY” indicator is off.
Power (Ignition) Switch
Performing the following operations when carrying the electronic key on your person
starts the hybrid system or changes Power switch modes.
Starting the hybrid system
To Next Page
Loading...
