Lexus RZ300e 2024 - Page 80

79
RZ450e_RZ300e_QG_U
 Vehicles with Digital Rearview Mirror
HomeLink
®
logo
Appears while HomeLink
®
is operat-
ing. When the menu button is pressed,
the logo disappears even while the
HomeLink
®
is operating.
Garage door operation indicators
HomeLink
®
indicator lights
Illuminates above each button
selected.
Buttons
Before programming the HomeLink
®
, perform the following:
● During programming, it is possible that garage doors, gates, or other devices may oper-
ate. For this reason, make sure that people and objects are clear of the garage door or
other devices to prevent injury or other potential harm.
● It is recommended that a new battery be placed in the remote control transmitter for
more accurate programming.
The battery side of the transmitter must be pointed away from the HomeLink
®
buttons.
● Garage door opener motors manufactured after 1995 may be equipped with rolling
code protection. If this is the case, you may need a stepladder or other sturdy, safe device
to reach the “learn” or “smart” button on the garage door opener motor.
Steps
1 through 3 must be performed within 60 seconds, otherwise the HomeLink
®
indi-
cator light will stop flashing and programming will not be successfully completed.
1 Press and release the HomeLink
®
button you want to program and check that the
HomeLink
®
indicator light flashes orange.
2 Point the remote control transmitter for the device at the rear view mirror, 1 to 3 in. (25
to 75 mm) from the HomeLink
®
buttons.
Keep the HomeLink
®
indicator light in view while programming.
A
B
C
D
Program the HomeLink
®