106
1-7. Loading luggage
■ Luggage compartment light
● The luggage compartment light turns on
when the back door is opened.
● If the luggage compartment light is left on
when the power switch is turned off, the
light will go off automatically after 20
minutes.
■ Power back door operating conditions
(vehicles with power back door)
With the power back door operations set to
ON, it can automatically open and close for
the following conditions:
● When the electronic key is being carried
and the power back door switch is
pushed
*
● When the wireless remote control is
used
*
● When the power switch is in ON, the
back door will operate if any of the fol-
lowing conditions are met, in addition to
the above conditions:
• Parking brake is engaged
• The brake pedal is depressed
• The shift position is in P
*
: When configured with the customization
function so that it can be operated after
being unlocked, operate the back door
after it has been unlocked.
■ Back door closer (vehicles with the
power back door)
In the event that the back door is left slightly
open, the back door closer will automati-
cally close it to the fully closed position.
Whatever the state of the power switch, the
back door closer operates.
■ Operation of the power back door
(vehicles with power back door)
● A buzzer sounds and the emergency
flashers flash twice to indicate that the
back door is opening/closing.
● When the power back door operations
are OFF, the power back door does not
operate but it can be opened and closed
by hand.
● When the power back door automati-
cally opens, if an abnormality due to peo-
ple or objects is detected, operation will
stop.
NOTICE
■ To prevent malfunction of the power
back door and back door closer
(vehicles with power back door)
Observe the following precautions. Fail-
ure to do so may lead to malfunction of
the power back door or back door
closer.
● Do not apply excessive force to the
back door while the back door closer
is operating.
● Make sure that there is no ice between
the back door and frame that would
prevent movement of the back door.
● Take care not to damage the sensors
(installed on the right and left edges of
the power back door) with a knife or
other sharp object.
If the sensor is disconnected, the power
back door will not close automatically.
■ Close & lock function
*1, 2
*1
: If equipped
*2
: This setting can be customized by
your Lexus dealer.
When closing the power back door using
the close & lock function, a different
buzzer than the normal one will sound
before the operation begins.
To check that the operation has started
correctly, check that a different buzzer
than the normal one has sounded.
Additionally, when the power back door
is fully closed and locked, operation sig-
nals will indicate that all of the doors have
been locked.
Before leaving the vehicle, make sure
that the operational signals have oper-
ated and that all of the doors are locked.
To Next Page
Loading...
