150
2-2. Driving procedures
● The turn signal lights can be operated
when the power switch is in ON.
● If the indicator flashes faster than usual,
check that a light bulb in the front or rear
turn signal lights has not burned out.
1 Move the lever to position 1.
The right turn signal lights will blink.
2 Move the lever to position 2 and
release it.
The right hand signals will flash 3 times.
3 Move the lever to position 3 and
release it.
The left hand signals will flash 3 times.
4 Move the lever to position 4.
The left turn signal lights will blink.
To drive using regenerative braking
power selection, operate the “-” or “+”
paddle shift switches with the shift posi-
tion in D.
The regenerative braking power can
then be selected by operating the “-”
and “+” paddle shift switches.
To return to normal D position driving,
hold the “+” paddle shift switch for a
certain amount of time.
The regenerative braking power
can be selected from 4 levels.
The regenerative braking power
becomes strong as the number of
the arrows of (regenerative
braking power indicator) on the
multi-information display increases.
Operations when turning
left or right or changing
lanes
By operating the turn signal lever,
the intent of the driver can be
shown as follows.
Changing the regenerative
braking power
Operating the paddle shift switches
enables driving with a fixed regen-
erative braking power when the
accelerator pedal is released or the
brake pedal is depressed.
Selecting regenerative braking
power
To Next Page
Loading...
