173
3-1. Driving when the surrounding area is dark
3
Driving according to the conditions
• When headlights or tail lights of vehicles
ahead are turned off, dirty, changing
color, or not aimed properly
• When the headlights are repeatedly
changing between the high beams and
low beams.
• When use of the high beams is inappro-
priate or when the high beams may be
flashing or dazzling pedestrians or other
drivers.
• When the vehicle is used in an area in
which vehicles travel on the opposite side
of the road of the country for which the
vehicle was designed, for example using
a vehicle designed for right-hand traffic in
a left-hand traffic area, or vice versa
• When it is necessary to disable the sys-
tem: P.269
• Situations in which the sensors may not
operate properly: P.273
■ Temporarily reducing front camera sen-
sitivity
The sensitivity of the front camera can be
temporarily reduced.
1 Turn the power switch off with the fol-
lowing conditions met.
● The headlight switch is in the or
“AUTO” position.
● The headlight switch lever is in the low
beam position.
● The Automatic High Beam switch is on.
2 Turn the power switch to ON.
3 Within 60 seconds after performing
step 2, push the headlight switch lever
to the high beam position then pull it to
the original position quickly 10 times,
then leave the lever in its original posi-
tion.
4 If the sensitivity is changed, the Auto-
matic High Beam indicator will blink 3
times.
1 Push the lever forward.
The AHB indicator will turn off and the
high beam indicator will turn on.
Pull the lever to its original position to
enable the Automatic High Beam sys-
tem again.
1 Press the Automatic High Beam
switch.
The AHB indicator will turn off.
Press the switch to enable the Auto-
matic High Beam system again.
Turning the high beams on/off
manually
Changing to the high beams
Changing to the low beams
To Next Page
Loading...
