340
6-2. Using the safe driving support functions
The blind spot monitor can be
enabled/disabled on of the Center
Display. (P.592)
When the blind spot monitor is off, the
driving assist information indicator
(P.240) will illuminate. At this time,
“Blind Spot Monitor OFF” will be dis-
played on the multi-information dis-
play.
Each time the power switch is turned to
ON, the blind spot monitor is enabled.
WARNING
● Keep the sensors and the surrounding
areas on the rear bumper clean at all
times.
If a sensor or its surrounding area on the
rear bumper is dirty or covered with
snow, the blind spot monitor may not
operate and a warning message will be
displayed. In this situation, clear off the
dirt or snow and drive the vehicle with
the operation conditions of the BSM
function (P.342) satisfied for approxi-
mately 10 minutes. If the warning mes-
sage does not disappear, have the
vehicle inspected by your Lexus dealer.
● Do not attach accessories, stickers
(including transparent stickers), alumi-
num tape, etc. to a sensor or its sur-
rounding area on the rear bumper.
● Do not subject a sensor or its sur-
rounding area on the rear bumper to a
strong impact.
If a sensor is moved even slightly off posi-
tion, the system may malfunction and
vehicles may not be detected correctly.
In the following situations, have your
vehicle inspected by your Lexus dealer.
• A sensor or its surrounding area is
subject to a strong impact.
• If the surrounding area of a sensor is
scratched or dented, or part of them
has become disconnected.
● Do not disassemble the sensor.
● Do not modify the sensor or surround-
ing area on the rear bumper.
● If a sensor or the rear bumper needs to
be removed/installed or replaced,
contact your Lexus dealer.
● Do not paint the rear bumper any
color other than an official Lexus color.
● The sensor is affected by the paint on
the surface of rear bumper.
If not repaired correctly, the Blind Spot
Monitor may not operate and warning
message will be displayed. If paint
repairs need, please consult your
Lexus dealer.
Turning the blind spot monitor
system on/off
To Next Page
Loading...
