COMFORT ADJUSTMENT
109
16sa33a
This indicator comes on when the ignition switch is turned
to the “ON” position. It goes off after about 6 seconds.
This means the front seat belt pretensioners are operating
properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side airbag sensors, occupant
detection sensor, seat belt buckle switch, front seat belt
pretensioner assemblies, inflators, warning light,
interconnecting wiring and power sources. (For details, see
”Service reminder indicators and warning buzzers” on page
38.)
16st05
1
Front airbag sensors
2
Front seat belt pretensioner assembly
3
SRS warning light
4
Airbag sensor assembly
5
Occupant detection sensor
6
Seat belt buckle switch
The front seat belt pretensioner system consists mainly of the
above components, and their locations are shown in the
illustration.
The front seat belt pretensioners are controlled by the airbag
sensor assembly. The airbag sensor assembly consists of a
safing sensor and airbag sensor.
When the front seat belt pretensioners are activated, an
operating noise may be heard and a small amount of
smoke−like gas may be released. This gas is harmless and
does not indicate that a fire is occurring.
Once the front seat belt pretensioners have been activated, the
seat belt retractors remain locked.
To Next Page
Loading...
