ELECTRICAL COMPONENTS
365
64sa23a
64sa25b
2. Turn the Phillips-head screwdriver one time for turning the
vertical movement adjusting bolt 2 (outside screw) in the same
way as step 1 in relation to the 5 turns of the Phillips-head
screwdriver for turning the vertical movement adjusting bolt 1
(inside screw).
INFORMATION
If 3 turns of the Phillips-head screwdriver are
appropriate for the vertical movement adjusting bolt
1 (inside screw) at step 1, turn the Phillips-head
screwdriver three fifth turns in the same direction as
step 1 for the vertical movement adjusting bolt 2
(outside screw).
The turning confirmation mark is stamped at the tip
of the vertical movement adjusting bolt 2 (outside
screw). Turn the Phillips-head screwdriver for
turning the vertical movement adjusting bolt 2
(outside screw) while checking this mark.
To Next Page
Loading...
