Lezyne Lever Kit - Page 2

USING A PATCH KIT TO FIX A FLAT
GLUELESS
1. Locate puncture hole in the tube.
2. Clean and roughen the area around the hole with the supplied scuffer
3. Peel off the backing from the patch and apply the patch over the hold while avoiding
touching the sticky (glue) side
4. Press and hold the patch firmly for 30 seconds
5. Reinstall tube and inflate
GLUE
1. Locate puncture hole in the tube.
2. Clean and roughen the area around the hole with the supplied scuffer
3. Apply glue and wait approximately 2 minutes or until glue is tacky
4. Press and hold the patch firmly for 30 seconds
5. Reinstall tube and inflate
TIRE BOOT
In the occurrence of a rip, slice, or tear in your tire, this boot can be used as a patch between your tire
and tube to help prevent your tube from blowing out of the damaged tire. Simply remove the clear film
to expose the glue and place the boot over the rip. Once you’ve reached your destination, immediately
replace your tire with a new one.
For Models
Lever Kit
Metal Kit
Alloy Kit
Smart Kit
Classic Kit
Lezyne Tire Repair User Manual – Download [optimized]
Lezyne Tire Repair User Manual – Download
Related Manuals:
1. Lezyne Floor Pump User Manual Floor Pump User Guide ABS FLIP THREAD CHUCK Match end...
2. Lezyne LED Light User Manual English User Manual READ ENTIRE MANUAL BEFORE OPERATION to ensure...
3. Lezyne LZ9 GPS Device User Manual User Manual READ ENTIRE MANUAL BEFORE OPERATION to ensure
proper...
4. Lezyne LZ7 LED light User Manual English User Manual READ ENTIRE MANUAL BEFORE OPERATION to
ensure...
5. Lezyne PWR SUP LED Light User Manual Lezyne PWR SUP LED Light User Manual READ ENTIRE
MANUAL...
6. Lezyne LZ7 Micro LED Light User Manual User Manual READ ENTIRE MANUAL BEFORE OPERATION to
ensure proper...