OUTDOOR WIRELESS
REMOTE CONTROL
OUTLETS
ITEM #357410
MODEL #UTTNOREM2
OPERATING INSTRUCTIONS
1. Remove the plastic battery tab
from the battery compartment
in the back of the remote
control to activate the
pre-installed battery.
2. Plug the receiver into a
grounded, 3-wire outdoor-
rated outlet, making sure there
is power to the outlet the
receiver is plugged into.
3. Plug the lights or devices to
be controlled into the receiver.
4. Press the ON/OFF buttons on
the remote control to turn the
lights or devices on or off. The
indicator light on the receiver
is lit when the unit is powered
on.
HELPFUL TIPS
• Make sure the receiver is plugged into a working AC outlet.
• Make sure the receiver and connected equipment are on.
• Make sure the remote control ON button is pushed.
• Make sure the battery in the remote control is still
functioning.
BATTERY REPLACEMENT
Use your finger to slide out the battery holder on the
right bottom corner of the remote. Remove the spent
battery and insert a new CR2032, 3V button-cell
battery with the “+” polarity mark facing up. Slide the
battery holder back inside. Dispose of the old battery
in compliance with all applicable laws. Contact your
local solid waste authority for detailed information.
WARNING: DO NOT DISPOSE OF BATTERIES IN
FIRE. BATTERIES MAY EXPLODE OR LEAK.
BATTERY SUPPLIER: Ningbo Jiangdong Qianshou
Fuhua Battery Co., Ltd.
• Non-rechargeable batteries are not to be recharged.
• Batteries are to be inserted with the correct polarity.
•
Exhausted batteries are to be removed from the product.
ENGLISH FRONT
Equipment
plugged
into the
receiver is
not
working.
Remote
does not
turn the
devices
on or off.
Connected
lights are not
in “ON”
position, they
are not
functioning,
remote is
not receiving
power or
remote
control ON
button is not
pushed.
Receiver and
transmitter
need to be
re-synched.
Ensure the connected
lights are functional by
plugging them directly
into the outlet. Be sure
the connected lights are
in the “ON” position if they
have their own switch.
Make sure the outlet the
receiver is plugged into is
active. Make sure the
remote control ON button
is pushed. Replace the
CR2032, 3V battery in the
remote control.
Plug the receiver into a
properly grounded outlet.
Within 15 seconds, press
and hold any button on
the transmitter. After 12
seconds the red light will
stop flashing on your
transmitter and receiver.
TROUBLESHOOTING
PROBLEM
POSSIBLE
CAUSE
CORRECTIVE
ACTION
Printed in China rev. 09-02202024 YL
IC REGULATORY STATEMENT
Under Industry Canada regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessary for successful
communication.
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
PRINT SPECIFICATIONS
File Name: UTTNOREM2 Instr Manual-UTIL-YL.ai
Final Proof & Approved: Y Rev Date: 09-02202024
Package Type: Instruction Manual (trim to size and fold)
Manual Dimensions: H: 8.5 W: 11.0
(all dimensions in inches)
Number of pages: 1 front and back PLUS 1 additional page front only
White 75 GSM minimum
1/1 Process Black Printing
Fonts are outlined.
COMMENTS:
The job will print on two sheets of 11.0” x 8.5” paper folded 3 times as
indicated on artwork. The nished manual will then be folded as many
times as necessary to t inside of the package behind the prongs.
3
4
1
2
FCC REGULATORY STATEMENT
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user authority to operate the equipment.
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including
interference that may cause undesired operation.
Notes: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
4.
Consult the dealer or an experienced radio/TV technician for help.
WARNING: CHOKING HAZARD – Small Parts.
Not for children under 3 years.
!
SAFETY INFORMATION
This is a “GROUNDED” device. The male plug
contains a ground pin and is only intended for
use with a three-pronged grounded outlet.
This device is for use with a 125 V AC power source.
125 V AC / 60 Hz
Do not attach a device that exceeds the unit ratings:
15 A / 1,875 W Resistive (General Purpose)
8 A / 1,000 W Tungsten (Incandescent)
1/3 HP (Horsepower Motor)
Do not plug heaters or heat producing devices such
as coffee makers, toasters, clothes irons, etc. into the
Outdoor Wireless Outlets.
UTILITECH and logo design are
trademarks or registered trademarks
of LF, LLC. All rights reserved.
SG24067
Lionbridge approval 3/1/22: WU-007861152
Lionbridge approval May 2021:
WU-006705940 (for add’l text)
Lionbridge approval: WU-012037554
January 2024 for Reese’s Law Spanish
To Next Page
Need help?
General
