LIP-7024LD User Guide
１９
8001 – 8200 iPECS-1200
801 – 824 iPECS-MG100
801 - 872 iPECS-MG300
Any CO/IP Line access —
9
When dialing on a CO line, which uses pulse style signals, you may
activate Dial Pulse to Tone Switchover changing to DTMF style dialing
for banking services, etc.
When placing an IP call, you must dial an IP address using ‘*’ in place of
the dot.
If Least Cost Routing is set-up, the number you dial will be analyzed
and the system will place the call on the least expensive route.
You may be assigned Dialing and/or CO/IP Line Access Restrictions,
in which case you will receive error tone if you attempt to dial or access a
restricted number/CO/IP line. CO/IP line and Station Class Of
Service (COS), which establish dialing restrictions, may vary during Day
and Night operation (Day/Night COS).
You may need to enter an Authorization code bef
ore placing calls, in
which case you will receive a second dial tone.
Your external calls may be subject to Call Time Restrictions, you will
receive a Call Warning Tone prior to disconnect.
NOTE—In the event of an emergency, assigned Emergency
numbers (ex., a 911 call) may be dialed from any station in the
System, regardless of a Station’s dialing restrictions (COS).
OPERATION
To place an external call:
ï‚· Lift the handset,
ï‚· Select/Dial the CO/IP line/group,
ï‚· Dial the desired number.
4.2.2 Waiting for the next available CO/IP line
If all the lines connected to your system are busy, you will receive an All
Trunks Busy signal. You may request to be notified when a line becomes
free.
OPERATION
To activate a queue if the selected/dialed line is busy:
ï‚· Select/dial a busy CO/IP line button,
ï‚· Press the CALL BACK button,
To Next Page
Loading...
Need help?
General
