LIP-8004D User Guide
Only an Attendant can assign System Speed Dial
numbers.
To place a call using System Speed Dial:
ï‚· Lift the handset,
ï‚· Press
SPEED,
ï‚· Dial the desired System Speed Dial bin number (200-999 for
iPECS-100 or 2000-4999 for iPECS-300 or 600).
3.3.4 Using and Entering Station Speed Dial Numbers
Each station in the iPECS-100 System is allocated
memory for 20 Station Speed Dial numbers (bins 00-
19) each up to 48 digits. The iPECS-300 & 600 each
support 100 Station Speed Dial numbers (bins (000-
099). The iPECS-MG 100 & 300 each support 50
Station Speed Dial numbers (bins 000-049). These
numbers are entered at the user’s station and may
include several ‘special’ instructions. Special
instructions and the corresponding button are:
PAUSE will momentarily stop dialing.
FLASH as 1
st
digit—Activate dial tone detect.
FLASH not as 1
st
digit—The system will generate a
flash on the CO line.
CALL BACK as 1
st
digit—Send digits as ISDN
Keypad Facility message.
‘*’ as 1
st
digit—Display Security, the stored
number will not be displayed when used.
‘*’ not as 1
st
digit—Dial Pulse to Tone Switchover,
the system will switch from pulse to tone dialing.
When entering a Speed Dial, a 16 character name may
be associated with the number for Dial by Name.
Char
acters are entered with two keystrokes as in the
chart shown.
20
To Next Page
Loading...
Need help?
General
