LG-Nortel ARIA SOHO User Manual (English)

Other manuals for LG-Nortel ARIA SOHO

Feature Description And Operation Manual271 pages

Installation Manual59 pages

Hardware Description And Installation Manual67 pages

Questions and Answers:

K
kyle47Jul 31, 2025
What to do if my LG-Nortel Gateway system does not operate?
- K
  Keith SextonJul 31, 2025
  If your LG-Nortel Gateway system does not operate, several factors could be at play. It could be due to a power short circuit in some board(s). In this case, check the connection of each board with the MBU. Also, check the PSU and look for a short circuit on the MBU or other boards. Press the Reset button when the DIP switch (SW1, for database protection) is in the default position. The issue might also stem from a bad board connection or a system database malfunction.
N
Natasha ThomasAug 5, 2025
How to fix noise on External MOH and Paging port in LG-Nortel Gateway?
- J
  jwilsonAug 5, 2025
  If you are experiencing noise on the External MOH and Paging port of your LG-Nortel Gateway, it could be due to induced noise on the wire between the system and the amplifier. Ensure that a shielded cable is in use as the connection wire between the system and the amplifier. Another potential cause is an excessive input level from the external music source. Try decreasing the output level of the external music source by using the volume control on the music source.
J
johnsonchristopherAug 9, 2025
What to do if SLT does not operate on LG-Nortel Gateway?
- K
  Kelsey DaltonAug 10, 2025
  If the SLT on your LG-Nortel Gateway does not operate, it could be caused by a bad MBU/CHB308/CSB316 or SLIB8 board. Exchange the board for one in good working condition. Another possible cause is a bad connection between the MBU/CHB308/CSB316 or SLIB8 and SLT. Check that the board connection between the lines of the SLT and DKT on the MDF, and fix any mismatching.
W
Wyatt MooreAug 15, 2025
Why DKTU does not operate in LG-Nortel Gateway?
- D
  dphillipsAug 15, 2025
  If your DKTU does not operate on the LG-Nortel Gateway, there are several possible reasons. It could be due to a bad extension circuit, in which case you should exchange the malfunctioning board for one in good working condition. Another reason could be a bad connection between the MBU /CHB308 and DKT. Check the connection between the SLT line and DKT on MDF, and fix any mismatching. Repair any broken connection between the System and DKT. The proximity of DKT and System can also be a reason, so check the distance between the MBU/CHB308 and the DKT. Finally, the DKT itself might be faulty. Plug the DKT into another extension port that has been verified as working. If the DKT still does not work properly, replace the DKT.