LG 24MP59HT - Attaching the Stand Base

- 9 -
LGE Internal Use OnlyCopyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
3.2.4.4. Confirm PRESET 6500K Color coordinates and Adjust PRESET 9300K Color coordinates .
* Set as Aging mode ON, by commanding AGING_ON/OFF command code.
* Select Module that is being used in present production by commanding MODULE SELECT.
* Send SYSTEM RESET command to set Module data.
* Input Full White Pattern (Video level : 700 mVp-p)
* 9300K color adjustment
This Model Non TCO-6.0 Appliance.
If this TCO 03 spec should be satisfied later, refer to below method.
Adjust to meet x = 0.287±0.005, y=0.303±0.005 in 5 minutes.
x= 0.285±0.005, y= 0.301±0.005 in 5~30 minutes.
x=0.283±0.005, y=0.298±0.005 over than 30minutes, and confirm.
Adjust to meet Y = over 150cdand confirm
 Input Full White Pattern (Video level : 700 mVp-p)
 Set as 6500K by commanding COLOR_MODE_CHANGE Command code.
 6500K color adjustment
If this TCO 03 spec should be satisfied later, refer to below method.
Adjust to meet x = 0.317 ± 0.005, y=0.332±0.005 in 5 minutes.
x= 0.315 ± 0.005 , y= 0.331±0.005 in 5~30 minutes.
x=0.313 ± 0.005, y=0.329±0.005 over than 30minutes, and confirm.
(Option) It’s another method for 6500K color adjustment at Gumi
& NT
At first, check ΔUV. If that is under 0.0065, the set is not adjusted.
If not. It is adjust to meet u’= 0.198±0.0065, v’=0.469±0.0065
Adjust to meet Y = over 200 cd and confirm.
3.2.5 Confirm Operation state.
3.2.5.1 Operation mode : Confirm whether each appointed mode operate correctly or not.
3.2.5.2 Confirmation of Adjustment condition and operation : Confirm whether it meet Auto/Manual
equipement Adjustment standard or not.
■ Confirm Analog screen state : Confirm screen state
at below mode.
Appointment mode : 640*480 @60Hz (Mode 2), 800*600@75Hz(Mode 5)
1024*768@60Hz(Mode 6), 1280*1024@60Hz(Mode 9)
1680*1050@60Hz(Mode 11)，1920*1080@60HZ(Mode 12)
SMPTE pattern(Check 0%,5%,95%,100%) –Mode can be added.
Check HDCP signal screen by using Video generator that generate HDCP signal
3.2.5.3. Confirm Auto adjustment operation.
 Input Analog 1 Dot on/off & Rectangle Pattern at Mode 12 1920x1080@60Hz;
 Confirm adjustment operation by changing Clock, Phase,H/V Position.
 Check Clock, Phase by pressing AUTO Key.