LG 32LG500H - Page 13

LGE Internal Use OnlyCopyright LG Electronics. Inc. All right reserved.
Only for training and service purposes
- 13 -
5.3. Auto RGB Color Balance
(1) Required Test Equipment
- Remote controller for adjustment
- 802F Pattern Generator, Master (MSPG-925FS), etc.
(Which has XGA 60Hz PC Format output with standard
(0.7Vpp) See Fig. 3 )
- It is very important to use correct adjustment pattern like
Fig.3.
(2) Method of Auto RGB Color Balance
1) Input the PC 1024x768 @ 60Hz into RGB.
=> MSPG-925FS Model No: 60 / Pattern No: 65
2) Set the EZ Pictures to Daylight mode in Video menu.
3) Press INSTART key on R/C for adjustment.
4) Press the
G(Vol. +) key operate To set, then it becomes
automatically.
5) Auto-RGB OK means completed adjustment.
5.4. RF Color Balance
1) Input the RF cable(2 ch)
2) Set the EZ Pictures to Daylight mode in Video menu.
3) Press INSTART key on R/C for adjustment.
4) Press the
G(Vol. +) key operate To set, then it becomes
automatically.
5) Auto-RGB OK means completed adjustment
Default Value on OSD
Auto Color Balance (Hex)
Auto-RGB G To Set
Source Main
Red Offset1 0F8
Green Offset1 0DA
Blue Offset1 0BC
Red Offset2 01
Green Offset2 01
Blue Offset2 01
Red Gain 1FE
Green Gain 1FE
Blue Gain 1FE
Reset G To Set
<Fig.3> Auto RGB Color Balance Test Pattern
Default Value on OSD
Auto Color Balance (Hex)
Auto-RGB G To Set
Source Main
Red Offset1 069
Green Offset1 0DA
Blue Offset1 0D0
Red Offset2 37
Green Offset2 39
Blue Offset2 3F
Red Gain 19F
Green Gain 183
Blue Gain 195
Reset G To Set
Default Value on OSD
Auto Color Balance (Hex)
Auto-RGB G To Set
Source Main
Red Offset1 032
Green Offset1 030
Blue Offset1 033
Red Offset2 40
Green Offset2 40
Blue Offset2 40
Red Gain 03C
Green Gain 03C
Blue Gain 01F
Reset G To Set