- 14 -
LGE Internal Use OnlyCopyright LG Electronics. Inc. All right reserved.
Only for training and service purposes
• Standard color coordinate and temperature using CA-
210(CH 14) – by aging time
1) Edge/IOP LED models
5.2. Tool Option setting & Inspection per
countries
(1) Overview
• Tool option selection is only done for models in Non-USA
North America due to rating
• Applied model: LA02D and LA02E Chassis applied to
CANADA and MEXICO
(2) Country Group selection
• Press ADJ key on the Adj. R/C, and then select Country
Group Menu
• Depending on destination, select KR or US, then on the
lower Country option, select US, CA, MX. Selection is
done using +, - KEY
(3) Tool Option Inspection
• Press Adj. key on the Adj. R/C, and then check Tool
option.
5.3. Local dimming inspection (Optional)
5.3.1. Edge LED models with local dimming
(1) Press ‘TILT” key of the Adj. R/C and check moving
patterns. The black bar patterns moves from left to right.
If local dimming function does not work, a whole screen
shows full white.
5.3.2. IOP LED models with local dimming
(1) Press ‘TILT” key of the Adj. R/C and check moving
patterns. The black cross-bar patterns moves from top-left to
Bottom-right. If local dimming function does not work, a whole
screen shows full white.
5.4. Ship-out mode check (In-stop)
• After final inspection, press In-Stop key of the Adj. R/C and
check that the unit goes to Stand-by mode.
To Next Page
Loading...
