- 14 -
LGE Internal Use OnlyCopyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
6. Model Name & Serial Number
Download
6.1. Model name & Serial number
(1) Press “Power on” key of service remote control.(Baud rate
: 115200 bps)
(2) Connect USB to RS232 Signal Cable to USB Jack.
(3) Write Serial number.
(4) Must check the serial number at the Diagnostics of SET
UP menu. (Refer to below).
6.2. Signal TABLE
CMD : A0h
LENGTH : 85~94h (1~16 bytes)
ADH : EEPROM Sub Address high (00~1F)
ADL : EEPROM Sub Address low (00~FF)
Data : Write data
CS : CMD + LENGTH + ADH + ADL + Data_1 + … + Data_n
Delay : 20ms
6.3. Command Set
* Description
FOS Default write : <7mode data> write
Vtotal, V_Frequency, Sync_Polarity, Htotal, Hstart, Vstart, 0,
Phase
Data write : Model Name and Serial Number write in
EEPROM.
6.4. Method & notice
(1) Serial number D/L is using of scan equipment.
(2) Setting of scan equipment operated by Manufacturing
Technology Group.
(3) Serial number D/L must be conformed when it is produced
in production line, because serial number D/L is mandatory
by D-book 4.0
Manual Download (Model Name and Serial Number)
If the TV set is downloaded By OTA or Service man,
Sometimes model name or serial number is initialized.( Not
always)
There is impossible to download by bar code scan, so It
need Manual download.
a. Press the ‘In start’ key of ADJ remote control.
b. Go to the menu ‘6.Model Number D/L’ like below photo.
c. Input the Factory model name(ex 32LV3400-ZG) or Serial
number like photo.
d. Check the model name Instart menu → Factory name
displayed (ex 49LH540V-ZA)
e. Check the Diagnostics (DTV country only) → Buyer model
displayed (ex 49LH540V-ZA)
7. MAC Address & CI+ Key Download
7.1. MAC Address
7.1.1. Equipment & Condition
▪ Play file : Serial.exe
▪ MAC Address edit
▪ Input Start / End MAC address
7.1.2. Download method
7.1.2.1. Communication Prot connection
Connection : PCBA (USB Port) USB to Serial Adapter
(UC-232A) RS-232C cable PC(RS-232C port)
Caution: LJ21* chassis support only UC-232A driver.
(only use this one.)
CMD LENGTH ADH ADL DATA_1 . . . Data_n CS DELAY
No. Adjust mode CMD(hex) LENGTH(hex) Description
1 EEPROM WRITE A0h 84h+n n-bytes Write
(n = 1~16)
To Next Page
Loading...
