LG 47LV3700 - Input tool option

- 19 -
4.4. Input tool option.
Adjust tool option refer to the BOM.
• Tool Option Input : PCBA Check Process
• Area Option Input : Set Assembly Process
After Input Tool Option and AC off
Before PCBA check, you have to change the Tool option and have to AC off/on (Plug out and in)
(If missing this process, set can operate abnormally)
4.4.1. Profile : Must be changed the option value because being different with some setting value depend on module maker, inch
and market
4.4.2. Equipment : adjustment remote control.
4.4.3. Adjustment method
- The input methods are same as other chassis.(Use ADJ Key on the Adjust Remocon.)
(If not changed the option, the input menu can differ the model spec.)
Refer to Job Expression of each main chassis ass’y (EBTxxxxxxxx) for Option value
Caution : Don’t Press “IN-STOP” key after completing the function inspection.
LGE Internal Use OnlyCopyright LG Electronics. Inc. All right reserved.
Only for training and service purposes
MODEL 55LW9500 47LW9500
Tool Option1 33115 33112
Tool Option2 5461 5461
Tool Option3 3327 3327
Tool Option4 35003 35003
Tool Option5 47695 47695
Tool Option6 697697
MODEL 55LW7700 47LW7700
42LW7700
Tool Option1 33083 33080 33078
Tool Option2 5461 5461 5461
Tool Option3 3327 3327 3327
Tool Option4 51387 51387 51387
Tool Option5 47693 47693 47693
Tool Option6 665 665 665
35044
3299635046
32998
33000
MODEL
55LV5500 47LV5500 42LV5500
LGD
42LV5500
CMI
32LV5500
LGD
32LV5500
CMI
Tool Option1 33003
Tool Option2 1365 1365 1365 1365 1365 1365
Tool Option3 3327 3327 3327 3327 3327 3327
Tool Option4 17593 17593 17593 17594 17594 17594
Tool Option5 8789 8789 8789 87898717 8717
Tool Option6 665 665 665 665 665 665
MODEL 47LW5700
42LW5700
32LW5700
Tool Option1 33192 33190 37284
Tool Option2 5461 5461 1365
Tool Option3 3327 3327 3327
Tool Option4 17593 17593 17594
Tool Option5 14933 14933 14933
Tool Option6 729 729 729
MODEL 72LZ9700 47LV3700 42LV3700 32LV3700
Tool Option1 33231 440 438 436
Tool Option2
13718 1495 1495 1495
Tool Option3 3327 33273327 3327
Tool Option4 43195 17594 17593 17594
Tool Option5 47693
8789
8789 8789
Tool Option6 665 649 649 649