LG 47LV3700 - Additional Set Assembly Tests; Local Dimming Inspection; Motion Remote controller Inspection; 3 D Function test

- 25 -
5.8. Local Dimming Inspection (Optional :
over 42”)
5.8.1. Edge LED models with local dimming
1) Press ‘TILT” key of the Adj. R/C and check moving
patterns. The black bar patterns moves from left to right. If
local dimming function does not work, a whole screen
shows full white.
5.6.2. IOP LED models with local dimming
1) Press ‘TILT” key of the Adj. R/C and check moving
patterns. The black cross-bar patterns moves from top-left
to Bottom-right. If local dimming function does not work, a
whole screen shows full white.
5.9. Internal press test
5.10. Motion Remote controller Inspection
5.10.1. Equipment : Motion remote controller for test, IR-KEY-
CODE remote controller for test Check battery before
test. (Recommend : Change battery for every Lot.)
5.10.2. Process
1) Push “Mute” or “ START” key for pairing between TV-set
and motion remote controller.
2) Push “OK” or “Enter” key, you can see the Cursor on
screen.
3) Push “Vol+” or “STOP” key, Disconnect Pairing.
5.11. 3D Function test
5.11.1. Equipment : Pattern Generator MSPG-3233, HDMI
mode 37, pattern No. 81
5.11.2. Process
1) Connect HDMI (HDMI mode 371, Pattern No. 81)
2) Insert 3D Mode, Select side by side mode.
3) Without 3D-glasses, Like below figure.
4) With 3D left-glass, Like below figure. (Center is RED)
5) With 3Dright-glass, Like below figure.(Center is Blue)
LGE Internal Use OnlyCopyright LG Electronics. Inc. All right reserved.
Only for training and service purposes
No Item Vallue Unit Remark
1.
Dielectric Voltage(AC<->FG) 1.5 kV At 100mA for 1sec(Line)
1.5 At 100mA for 1min(OQC)
2.
Dielectric Voltage(Without FG) 3 kV At 100mA for 1sec(Line)
3 At 100mA for 1min(OQC)