17
Registering magic remote
How to register the magic remote
To use the Magic Remote, rst pair it with your TV.
1 Put batteries into the Magic Remote and turn the TV on.
2 Point the Magic Remote at your TV and press the Wheel (OK) on
the remote control.
* If the TV fails to register the Magic Remote, try again after turning the
TV o and back on.
How to deregister the magic remote
Press the (BACK) and (HOME) buttons at the same time, for
ve seconds, to unpair the Magic Remote with your TV.
* Pressing and holding the
button will let you cancel and re-
register Magic Remote at once.
How to use magic remote
• Shake the Magic Remote slightly to the right and left or press
(HOME), (INPUT), buttons to make the pointer appear
on the screen.
(In some TV models, the pointer will appear when you turn the
Wheel (OK) button.)
• If the pointer has not been used for a certain period of time or
Magic Remote is placed on a at surface, then the pointer will
disappear.
• If the pointer is not responding smoothly, you can reset the pointer
by moving it to the edge of the screen.
• The Magic Remote depletes batteries faster than a normal remote
due to the additional features.
Precautions to take when using the
magic remote
• Use the remote control within the specied range (within 10 m).
You may experience communication failures when using the device
outside the coverage area or if there are obstacles within the
coverage area.
• You may experience communication failures depending on the
accessories.
Devices such as a microwave oven and wireless LAN operate in the
same frequency band (2.4 GHz) as the Magic Remote. This may
cause communication failures.
• The Magic Remote may not work properly if a wireless router (AP)
is within 1 meter of the TV.
Your wireless router should be more than 1 m away from the TV.
• Do not disassemble or heat the battery.
• Do not drop the battery. Avoid extreme shocks to the battery.
• Inserting the battery in the wrong way may result in explosion.
Licenses
Supported licenses may dier by model. For more information about
licenses, visit www.lg.com.
Open source software
notice information
To obtain the source code under GPL, LGPL, MPL, and other open source
licenses, that is contained in this product, please visit http://opensource.
lge.com.
In addition to the source code, all referred license terms, warranty
disclaimers and copyright notices are available for download.
LG Electronics will also provide open source code to you on CD-ROM
for a charge covering the cost of performing such distribution (such
as the cost of media, shipping, and handling) upon email request to
opensource@lge.com. This oer is valid for three (3) years from the date
on which you purchased the product.
(Australia region only)
FreeviewPlus provides access to content and services from the
Freeview networks. The FreeviewPlus service provides a 7 + day
EPG, all available Catch Up TV, recommendations and the ability
to set reminders and favourites. FreeviewPlus is available by
pressing the green button on the remote.
*FreeviewPlus uses HbbTV technology which combines broadcast
and broadband. It requires an internet connection. Normal data
usage charges and conditions apply.
To Next Page
Loading...
Need help?
General
