ENGENGLISH
29
INSTALLATION MENU
StandBy
-
Set the sending and receiving scenario of OpStandBy(0x0c) command.
-
Ths detailed scenario is described on the table below.
Send Receive
Send Only O X
Receive Only X O
All O O
Off X X
Forced Initialize
-
This setting will be enabled When CEC mode is set as ‘TVLink-CEC’
-
If ‘Enable” is selected, TV will change its input source to HDMI1 by any HDMI-CEC simulation from a device.
HTNG Hotel Mode
-
If you use following functions via TVLink-HCEC, HTNG Hotel mode will be set as “Yes” automatically. (*Power On Default,
Start Volume, Maximum Volume, Minimum Volume, or Start Volume)
-
Even if ‘Hotel Mode Operation’ is set as No, above settings are still effective.
To Next Page
Loading...
