EasyManua.ls Logo

LG 65UF9500 - Page 22

LG 65UF9500
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 22 -
LGE Internal Use OnlyCopyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes
** G-fix adjustment
Adjust modes (Cool), Fix the G gain to 172 (default data) and
change the others (R/B Gain ).
Adjust two modes (Medium / Warm), Fix the one of R/G/B gain
to 192 (default data) and decrease the others.
If internal pattern is not available, use RF input. In EZ Adj.
menu 7.White Balance, you can select one of 2 Test-pattern:
ON, OFF. Default is inner(ON). By selecting OFF, you can
adjust using RF signal in 216 Gray pattern.
Adj. condition and cautionary items
(1) Lighting condition in surrounding area
Surrounding lighting should be lower 10 lux. Try to isolate adj.
area into dark surrounding.
(2) Probe location
- PDP: Color Analyzer (CA-100, CA-100+, CA210) probe
should be firmly attached to the Module
- LCD: Color Analyzer (CA-210) probe should be within 10cm
and perpendicular of the module surface (80°~ 100°)
(3) Aging time
- After Aging Start, Keep the Power ON status during 5
Minutes.
- In case of LCD, Back-light on should be checked using no
signal or Full-white pattern.
5.3.6. Reference (White Balance Adj. coordinate and
color temperature)
▪ Luminance: 206 Gray
Standard color coordinate and temperature using CS-1000
(over 26 inch)
Mode
Coordinate
Temp uv
X Y
Cool 0.271 0.270 13,000K 0.0000
Medium 0.286 0.289 9,300K -3
Warm 0.313 0.329 6,500K 0.0000
Standard color coordinate and temperature using CA-210
(CH 14)
Mode
Coordinate
Temp uv
X Y
Cool 0.271±0.002 0.270±0.002 13000K 0.0000
Medium 0.286±0.002 0.289±0.002 9300K -3
Warm 0.313±0.002 0.329±0.002 6500K 0.0000
5.3.7. EDGE & IOL LED White balance table
Edge & ALEF LED module change color coordinate because
of aging time
apply under the color coordinate table, for compensated
aging time
(Normal line) White balance table
- gumi(Mar~Dec) & Global
Model : (normal line)LGD
webOS
Aging time
(Min)
Cool Medium Warm
X Y X Y X Y
271 270 286 289 313 329
1 0-2 282 289 297 308 324 348
2 3-5 281 287 296 306 323 346
3 6-9 279 284 294 303 321 343
4 10-19 277 280 292 299 319 339
5 20-35 275 277 290 296 317 336
6 36-49 274 274 289 293 316 333
7 50-79 273 272 288 291 315 331
8 80-119 272 271 287 290 314 330
9 Over 120 271 270 286 289 313 329
- Gumi Winter table(Jan, Fab) – Gumi producing model use only
Model : (normal line) LGD
Same as non-winter table
webOS
Aging time
(Min)
Cool Medium Warm
X Y X Y X Y
271 270 286 289 313 329
1 0-2 282 289 297 308 324 348
2 3-5 281 287 296 306 323 346
3 6-9 279 284 294 303 321 343
4 10-19 277 280 292 299 319 339
5 20-35 275 277 290 296 317 336
6 36-49 274 274 289 293 316 333
7 50-79 273 272 288 291 315 331
8 80-119 272 271 287 290 314 330
9 Over 120 271 270 286 289 313 329
(*) AUO, INX, Sharp, CSOT, BOE using model (Cool 13000K The
Spec in this case.): DV standard
webOS Cool Medium Warm
x y x y x y
271 270 285 293 313 329
Target 278 280 293 299 320 339

Related product manuals