• Auto addressing setting end
Numbers of indoor unit connection set whose
addressing is completed are indicated for 30seconds
on 7-segment LED after completing setting
Indoor address number is displayed on wired remote control or
indoor unit display window. It is not an error message, will
disappeared when on/off button is pressed on remote control
ex) Display of 01 means connection of 01 indoor units and auto
addressing is completed normally.
Auto addressing start
Waiting 3 minutes
Power On
Press SW02V for 5 s
7-segment LED = 88
Waiting about 2~7 minutes
7-segment LED
OK
YES
NO Check the connections
of communication line
= 88
All DIP switch should be off before auto adressing
To Next Page
Loading...
