108 Multi type Air Conditioner
1) Two Thermistor System
(1) Open the rear cover of the wired remote-controller to set the mode.
(2) Select one of three selectable modes as follows.
• Position 1:
The room temperature is controlled by the thermistor of the main body.
• Position 2:
The room themperature is controlled by the thermistor of the wired remote-controller, control the
temperature according to the position of wired remote-controller.
• Position 3:
The room temperature is controlled by lower temperature between the temperature of main body and of
remote-controller sensor.
(3) Move the slide switch to set position.
(4) Close the rear cover and check if it works normally.
CAUTION: • Select the position after counselling with a customer.
• In case of cooling mode, room temperature is controlled by the
main body sensor.
• To control the room temperature by a wired remote controller,
install controller(room temp. sensor) to sense the temperature
more accurately.
• Maunfactured in the position 1.
Operation
To Next Page
Loading...
Need help?
General
