14 | INTRODUCTION
Single Zone Art Cool Premier Owner’s Manual
Due to our policy of continuous product innovation, some specications may change without notication.
ADVANCED FUNCTIONS
Jet Cool/Heat Operation -
Auto Changeover Operation
Follow the operational directions in this section to work with advanced functionality and features of the Art Cool Premier Wall Mounted system.
Jet Cool/Heat Operation
Rapid Cooling and Heating of Room Temperature
This functionality allows you to rapidly cool indoor air (during sum-
mer months) or warm indoor air (during winter months).
1. Press to turn on the power.
2. Press the Jet button .
•In Jet Cool Mode, unit operates at a setpoint of 64.4 °F (18 °C) for
a duration of 30 minutes.
• In Jet Heat Mode, unit operates at a setpoint of 86 °F (30 °C) for a
duration of 30 minutes.
• Jet Cool/Heat Mode cannot be run during Air Circulation, Auto, or
Auto Changeover Modes.
• This function may not be supported on all Single Zone Inverter models.
Auto Clean Operation
Indoor Air Purification
While in cooling and dehumidifying mode, the air conditioner gener-
ates moisture on the interior of the indoor unit. The Auto Clean
operation is used to remove this type of moisture.
1. Press to start dehumidifying operation.
• is displayed on the Remote Control display screen.
• If the power is turned off, the fan will operate for 30 minutes and will
clean the inside of the indoor unit.
• Some buttons (functionality) will not operate while the system is in
Auto Cleaning Mode.
Artificial Intelligence
Auto Operation - (Cooling Only Models)
During this functionality, the fan speed and the temperature adjust
automatically, based on room temperature.
1. Press to turn on the power.
2. Press the Mode button repeatedly to select Auto operation
(see icon in Figure 8 below).
3. Press the up and down arrows to select the desired
numerical operation code for cooling/heating strength. See the
table in Figure 8 below for a description of each numerical value.
• During the Artificial Intelligence Mode, you cannot adjust the fan
speed.
• During this mode, you can set the air deector to rotate automatically.
• This function may not be supported on all Single Zone Inverter models.
Code Description
2 Cool
1 Cool slightly
0 Maintain
room
temperature
-1 Heat slightly
-2 Heat
Figure 8: Auto Intelligence Screen with Code Description
Auto Changeover Operation
This functionality changes the operation mode automatically to main-
tain a set temperature of ± 3.6 °F (±2 °C).
1. Press to turn on the power.
2. Press the Mode button repeatedly to select Auto operation
(see icon display in red box in Figure 9 below).
3. Press the up and down arrows to select the desired
temperature.
•The temperature range is 64.4 °F (18 °C) through 86 °F (30 °C).
4. Press repeatedly as needed to adjust the fan speed.
Auto Changeover
Figure 9: Auto Changeover Display
• This function may not be supported on all Single Zone Inverter models.
• You screen display may look slightly different depending on your DFS
Inverter model.
°C/°F Screen Display
The Single Zone Art Cool Premier unit can be set in either °C or °F
temperature readout, by pressing and holding the Room Tempera-
ture button for 5 seconds.
• This function may be not supported on all DFS Inverter models.
To Next Page
Loading...
