EasyManua.ls Logo

LG AUUW096D - Page 28

LG AUUW096D
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28
Remote Controller Installation
Operation uni
t
ZO
N
E
1
2
3
4
Humidify
JET
AUTO
AUTO SWING
OPERATI
O
N
FAN SPEED
Program se
t
S
U
B
FUNCTION
S
E
T TEMP
Room T
emp
HI
MED
LO
Heater
Defrost
F
ilt
er
P
reheat
Out door
T
ime
T
imer
On
Set
n
o.
Time
Of
f
0
1
03
05
0
7
09
11
13 15
17
19
21
23
5feet
(1.5meters)
Direct
Sun ray contact area
no
no
no
yes
Operation unit
Z
ONE
1
2
3
4
Hum
idify
JET
AUTO
AUTO SWING
OPERATION
FAN SPEED
Progr
am set
S
UB FUNCTI
O
N
SET TEMP
Ro
o
m Te
mp
HI
M
ED
L
O
Heater
Defrost
Filter
Preheat
O
u
t door
Time
T
imer
O
n
Set
no
.
Time
Off
01
0
3
05
0
7
09
11
13
15
17
19
21
2
3
Fig.1 Typical locations for remote controller
Wireless Remote Controller
HOW TO MOUNT ONTO A WALL
How to insert the Batteries
1. Remove the battery cover by
pulling it according to the arrow
direction.
2. Insert new batteries making sure
that the (+) and (-) of battery are
installed correctly.
3. Reattach the cover by sliding it
back into position.
1. Always use/replace both batteries
of same type.
2. If the system is not to be used for
a long time, remove the batteries
to save their working life.
3. If the display screen of remote
controller starts, fading replace
both of the batteries.
NOTICE
• Since the room temperature sensor is in the remote controller, the remote controller box should be installed
in a place away from direct sunlight, high humidity and direct supply of cold air to maintain proper space
temperature. Install the remote controller about 5ft(1.5m) above the floor in an area with good air circulation
at an average temperature.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of the remote
controller LED's, the remote controller should be installed properly as shown in Fig.1.
(The standard height is 1.2~1.5 m from floor level.)
Wired remote controller installation
1,MFL67855401,영영 2017. 6. 29. 영영 1:50 Page 28

Related product manuals