Troubleshooting 13
Problem Cause & Correction
The portable device
couldn’t be charged as
the portable battery’s
capacity.
•Depending on the voltage of the portable
battery and the portable device, the
charging eciency is various. For example,
if portable device’s battery has 2000 mAh
capacity, it isn’t possible to charge the
portable device over ve times by using
10400 mAh of portable battery. The actual
available capacity is below 10400 mAh.
(about 70 % - 80 % is available)
A LED keeps blinking fast.
(BP3 2600 mAh: purple
LED Keeps blinking fast,
BP4 10400 mAh, BP4
5200 mAh: All LEDs keep
blinking fast.)
•In case of abnormal
circumstance
- Using the unit at too
much low degree(below
5 °C (41 °F)) or too much
high degree(above
35 °C (95 °F)).
- An operation of a
short circuit by external
environment.
- Input or output to
an overcurrent or
overvoltage.
•That means it is an abnormal circumstance
or a short circuit of the unit occurs. Stop
using the unit immediately. If you make
the normal circumastance, it will work
properly again.
•If the unit does not work properly even
under the normal circumstance for long,
press the LED button once.
•If the LED Lights keep blinking fast under
the normal circumstance, contact the
service center.
•It will work properly that you should
disconnect the charger from the portable
battery rst and then re-connect them.
BP410_BP405_BP302_ENG_TAY35387870.indd 13 2014-04-30 �� 9:55:58
To Next Page
Loading...
