EasyManuals Logo

LG DLE3090 Series User Manual

LG DLE3090 Series
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
48 TROUBLESHOOTING
Problem Possible Cause Solutions
Clothes take too
long to dry
Large load of heavy fabrics.
Heavy fabrics take longer to dry because they tend
to retain more moisture. To help reduce and maintain
more consistent drying times for large and heavy
fabrics, separate these items into smaller loads of a
consistent size.
Dryer controls are not set
properly.
Use the appropriate control settings for the type of load
you are drying. Some loads may require an adjustment
of the dry level setting for proper drying.
Lint lter needs to be cleaned.
emove the lint from the filter efore ever load. ith
the lint removed hold the filter p to a liht to see if it
is dirty or clogged. With some loads that produce high
amounts of lint, such as new bath towels, it may be
necessar to pase the ccle and clean the filter drin
the cycle.
House fuse is blown, circuit
breaker has tripped, or power
outage has occurred.
Reset circuit breaker or replace fuse. Do not increase
fuse capacity. If the problem is a circuit overload, have
it corrected  a alified electrician.
NOTE: Due to the design of electric dryers, it is
possible for a circuit problem to allow an electric dryer
to run without heat.
Dryer is overloaded.
Divide extra large loads into smaller loads for better
drin performance and efficienc.
Dryer is underloaded.
If you are drying a very small load, add a few extra
items to ensure proper tumbling action. If the load is
very small and you are using SENSOR DRY cycles, the
electronic control cannot properly sense the dryness of
the load and may shut off too soon. Use TIME DRY or
add some extra wet clothes to the load.
ENERGY SAVER option
selected (on some models)
If using the Normal cycle, deselect the ENERGY
SAVER option. This option reduces energy use by
adding an air dry section to the beginning of the cycle.
Drying time is not
consistent
Heat settings, load size, or
dampness of clothing is not
consistent.
The drying time for a load will vary depending on the
type of heat used (electric, natural gas, or LP gas),
the size of the load, the type of fabrics, the wetness of
the clothes, and the condition of the exhaust duct and
lint filter. ven an nalanced load in the asher can
cause poor spinning, resulting in wetter clothes which
will take longer to dry.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LG DLE3090 Series and is the answer not in the manual?

LG DLE3090 Series Specifications

General IconGeneral
BrandLG
ModelDLE3090 Series
CategoryDryer
LanguageEnglish

Related product manuals