39
,
Place the shorter duct section into the dryer.
Install a screw through the holding tab to the
bracket in the base of the dryer.
Attach the 4-inch elbow to the remaining
4-inch duct. Wrap the joint using dust tape.
(Use real adhesive-brasked foil tape, not
the cheap fabric type sold in discount stores.)
Insert the elbow duct assembly through the side
or base opening and connect the elbow to the
internal duct.
Using shorter pieces of duct tape, reach
through the vent hole and wrap the duct
joint inside the dryer. Then install the cover
over the hold to prevent the entry of vermin.
※ All necessary vent conversion parts are included in the dryer vent kit, part number 3911EZ9131X
To Next Page
Loading...
Need help?
General
