LG DLEX3370V - High-Altitude Installations

22 INSTALLATION
NOTE
• In the Commonwealth of Massachusetts: This
product must be installed by a licensed plumber
or gas tter. When using ball-type gas shut off
valves, they shall be T-handle-type. A exible gas
connector, when used, must not exceed 3 feet.
This dryer is congured from the factory for natural
gas (NG). If the dryer is to be used with propane
(LP) gas, it must be converted by a qualied service
technician.
1
Make sure that the gas supply to the laundry
room is turned OFF and the dryer is unplugged.
Conrm that the type of gas available in your
laundry room is appropriate for the dryer.
2
Remove the shipping cap from the gas tting at
the back of the dryer. Be careful not to damage
the threads of the gas connector when removing
the shipping cap.
3
Connect the dryer to your laundry room’s gas
supply using a new exible stainless steel
connector with a 3/8-inch NPT tting.
NOTE
• DO NOT use old connectors.
4
Securely tighten all connections between the
dryer and your laundry room’s gas supply.
5
Turn on your laundry room’s gas supply.
6
Check all pipe connections (both internal and
external) for gas leaks with a noncorrosive leak-
detection uid.
7
Proceed to Venting the Dryer.
3/8" NPT gas
Connection
AGA/CSA-Certied
Stainless Steel Flexible
Connector
Gas Supply Shutoff
Valve
1/8" NPT Pipe Plug
High-Altitude Installations
The BTU rating of this dryer is AGA-certied for
elevations below 10,000 feet.
If your gas dryer is being installed at an elevation
above 10,000 feet, it must be derated by a qualied
technician or gas supplier.