40
MAINTENANCE
EN
means it must be cleaned regularly to
remove any build-up of lime scale on the
surface of the sensor.
Wipe the sensors inside the drum.
• Do not wipe the moisture sensor with
abrasive materials. Always clean the
sensor with a dry rough acrylic sponge.
Cleaning the Cool Air Inlet Grill
Vacuum the cool air inlet grill 3 - 4 times
a year to make sure there is no build up
of lint or dirt that may cause improper air
flow.
• Warm air is expelled through the
ventilation grill.
• Adequate room ventilation should be
provided to avoid the back flow of
gases into the room from units
burning other fuels, such as open fires.
To Next Page
