LG FRIDGE - Integrated door panel related work

13
10. Place the paper jig ⑨ on the reference line of the paper jig at the rear side of the
furniture door. (See Figure 7)
※※
Reference - Place the reference line of the paper jig at 1595mm from the floor of the cabinet.
- If the integrated door panel is long, place the reference line of the paper jig at
1595mm plus ‘A’ from the floor of the furniture.
Before fixing with the wood screw ⓑ,
double check the indicated point is located
in an accurate position.
11. Mark two points in the paper Jig ⑨ on the
integrated door panel. (See Figure 8)
9
A
1595mm
(Figure 7)
Reference line
of paper jig (for
the right hinge)
Reference line
of paper jig (for
the left hinge)
(Figure 8)
⑨
12. After removing the paper jig ⑨ , fix the top
bracket ⑩ of the integrated door panel by
using the wood screw ⓑ (4 places) with the
top two holes lined up to the marked spots
(from the paper jig) on the integrated door
panel. (See Figure 9)
※※
Reference - If you need to re-position top bracket
due to incorrect positioning. Align
top two holes to remarked position
(from jig) but use alternate holes to
fix to assure screws hold firmly.
(Figure 9)
b
b
10
6. Procedure to install
3) Integrated door panel related work