(Figure 17)
(Figure 18)
Door top
Door center
Door bottom
⑪
⑭
⑭
⑫
⑬
b
20. Use the wood screws ⓑ (four spots) to the depth adjusting bracket ⑦, move the integrated
door panel in or out to adjust the depth gap to 4mm (See Figure 14, Figure 17), and secure
the loosely fixed bracket screw ⓔ (Figure 1) to fix the depth adjusting bracket ⑦.
19. Move the integrated door panel in or out to
adjust the depth gap to 4mm (See Figure
14), and fix the depth adjusting bracket ⑫ to
both sides (two spots) of the refrigerator door
with the door screw ⓐ. (Figure 16)
21. Place the top bracket cover ⑪ on the door top and place the depth adjusting bracket
cover ⑫ and ⑭ on the middle and the bottom of the door respectively. (See Figure 18)
7
(Figure 16)
a
12
To Next Page
Loading...
