47
Body-worn Operation
This phone was tested for typical body-worn operations with the back
of the phone kept at a distance of 1.5 cm from the body. To maintain
compliance with FCC RF exposure requirements, use accessories that
maintain a 1.5 cm separation distance between your body and the back
of the phone. The use of belt clips, holsters and similar accessories
should not contain metallic components.
The use of accessories that do not satisfy these requirements may not
comply with FCC RF exposure requirements, and should be avoided.
The FCC has granted an Equipment Authorization for this model
handset with all reported SAR levels evaluated as in compliance
with the FCC RF emission guidelines. SAR information on this model
handset is on le with the FCC and can be found under the Display
Grant section of http://www.fcc.gov/oet/ea/fccid/ after searching on
FCC ID ZNFD722J.
Additional information on Specic Absorption Rates (SAR) can be found
on the Cellular Telecommunications & Internet Association (CTIA)
website at http://ctia.org/.
Export Administration
Regulations This product and its accessories may fall under the
category of application of Japan Export Control Regulations ("Foreign
Exchange and Foreign Trade Law" and relevant laws and regulations).
U.S. Re-export Regulations (Export Administration Regulations) is
applied to this product and its accessories. If you export or re-export
this product or its accessories, please follow the necessary procedures
at your own risk and expense. For details on the procedures, contact
the Ministry of Economy, Trade and Industry or the U.S. Department of
Commerce.
To Next Page
Loading...
