36 MAINTENANCE
Replace with a new water lter.
• Take the new water lter out of its packing
and remove the protective cover from the
o-rings.
With the water lter tabs in the
horizontal position, push the new water
lter into the manifold hole and turn it
clockwise until it stops.
Swing the lter up into place in the enclosure.
Close the cover until it clicks into place.
After the water lter is replaced, dispense 2.5
gallons of water (ush for approximately 5
minutes) to remove trapped air and
contaminants from the system.
After changing the lter, press and hold the
Water Filter button for three seconds to reset
the indicator light.
4
5
6
7
NOTE
• Replacing the water lter causes a small amount
of water (around 1 oz. or 25 cc) to drain.
• Wrap a cloth around the front end of the water
lter cover to collect any leaking water. Hold the
water lter upright, once it is removed, to
prevent any remaining water from spilling out of
the water lter.
NOTE
• Do not dispense the entire 2.5 gallon amount
continuously. Press and release the dispenser
pad for cycles of 30 seconds ON and 60 seconds
OFF.
To Next Page
Loading...
